71
(11)ELECTRICAL SYSTEM
REINSTALLATION
1.Glow plug installation
Install the glow plug in position in the
precombustion chamber and tighten in to the
specified torque.
2.Alternator installation
(1)Put the alternator in position. Install the
adjusting plate bolt in position to hold the
alternator in position.
(2)Put the belt in position on the pulley.
Move the alternator away from the engine
to make an adjustment to the belt.
(3)Tighten the bolts.
(4)Make sure the deflection(tension)of the
belt is correct.
Unit:in.(mm)
Deflection under 22 lbs 0.4 to 0.5
(10 kgf)[98 N] force (10 to 12)
1.75 0.25 kgf•m
(12.7 1.8 lbf•ft)
[17.2 2.5 N•m]
Tightening torque
To Next Page
Loading...
Need help?
General