20
6. Shuttle wire installation.
1) Set the length of wire at transmission side to
5.8 in (147 mm).
2) Set the length of wire at shuttle lever side
to 6.5in (164 mm).
*Amount of screw into the ball joint must be
0.32 in (8 mm)
3) After set of the wire lengths, adjust the wire
length by nut to obtain the shuttle shift lever
neutral position at lever guide. In the neutral
position, shuttle shift lever can be move side
to side.
7. Brake pedal adjustment (See page 127)
Free play : 0.99~1.39in (25 ~35 mm)
Adjust the left and right brake pedal height
difference to be less than 0.12in (3 mm).
8. Clutch pedal free play
[0.787~1.181 in.]
9. After reinstall the harnesses and tachometer
cable, clamp them not to touch the muffler,
manifold and fan belt.
To Next Page
Loading...
Need help?
General