4 Configuration DGS-1210 series Metro Ethernet Managed Switch User Manual
34
Host IP Address: Select IPv4 or IPv6 and specify the IP address of SNMP management host.
SNMP Version: Specify the SNMP version to be used to the management host.
Community String/SNMPv3 User Name: Specify the community string or SNMPv3 user name for the
management host.
Figure 4.32– System > SNMP Settings > SNMP Host Table
Click Apply to create a new SNMP host, Delete to remove an existing host.
System > SNMP Settings > SNMP Engine ID
The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.
Input the Engine ID then click Apply to apply the changes and click Default resets to default value.
Figure 4.33 – System > SNMP Settings > SNMP Engine ID
System > SNMP Settings > SNMP Trap Settings
The SNMP Trap Settings page provide user to Specify whether the device can send SNMP notifications.
Figure 4.34 – System > SNMP Settings > SNMP Trap Settings
SNMP Authentication Traps: Specifies the device to send authentication failure notifications.
System Coldstart Traps: Specifies the device to send SNMP coldstart notifications.
System Warmstart Traps: Specifies the device to send SNMP warmstart notifications.
To Next Page
Loading...
Need help?
General