4 Configuration DGS-1210 series Metro Ethernet Managed Switch User Manual
62
Click the Delete button to remove the specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Edit button to re-configure the specific entry.
After clicking the Edit button, the following page will appear:
Figure 4.86- Configuration > IGMP Snooping > IGMP Snooping Static Group Settings - Edit
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Configuration > MLD Snooping > MLD Snooping Settings
The MLD Snooping Settings page allows user to configure the max multicast group for IGMP Snooping.
Figure 4.87- Configuration > MLD Snooping > MLD Snooping Settings
MLD Snooping: Enable or disable the MLD Snooping.
MLD Global Settings:
Host Timeout (130-153025 sec): Specifies the time interval in seconds after which a port is removed from a
Multicast Group. Ports are removed if a Multicast group MLD report was not received from a Multicast port
within the defined Host Timeout period. The possible field range is 130 - 153025 seconds. The default
timeout is 260 seconds.
Router Timeout (60-600): Specifies the time interval in seconds the Multicast router waits to receive a
message before it times out. The possible field range is 60 - 600 seconds. The default timeout is 125
seconds.
Max Learned Entry Value (1-1024): Specifies the max learned entry value for MLD Snooping. The field
range is 1-1024. The default is 256.
Click Apply to make the configurations take effect. Press the Edit button under Router Port Setting, and
To Next Page
Loading...
Need help?
General