D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1002
Format
show poe ports {<portlist>}
Parameters
ports - (Optional) Specifies the list of ports to be displayed here.
<portlist> - Enter the list of ports, used for the display, here.
If no parameter is specified, the system will display the status for all the ports.
Restrictions
None.
Example
To display PoE port configurations on port 1 to 6:
DGS-3620-28PC:admin# show poe ports 1:1-1:6
Command: show poe ports 1:1-1:6
Port State Priority Power Limit(mW) Time Range
Class Power(mW) Voltage(decivolt) Current(mA)
Status
===============================================================================
1:1 Enabled Critical 4000 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:2 Enabled Critical 4000 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:3 Enabled Critical 4000 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:4 Enabled Critical 4000 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:5 Enabled Low 7000 (User-defined)
0 0 0 0
OFF : Interim state during line detection
1:6 Enabled Low 7000 (User-defined)
0 0 0 0
OFF : Interim state during line detection
DGS-3620-28PC:admin#
86-4 show poe system
Description
This command is used to display the settings and actual values of the whole PoE system.
Note: This command is only available to Switches in the DGS-3620 Series that support Power
over Ethernet.

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English