D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1199
Chapter 111 Surveillance VLAN
Commands
enable surveillance_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
disable surveillance_vlan
config surveillance_vlan priority <int 0-7>
config surveillance_vlan oui [add | delete] <macaddr> <macmask> {component_type [vms |
vms_client | video_encoder | network_storage | other] description <desc 32>}
config surveillance_vlan ports [<portlist> | all] state [enable | disable]
config surveillance_vlan aging_time <min 1-65535>
config surveillance_vlan log state [enable | disable]
show surveillance_vlan {[oui | ports {<portlist>} | device {ports <portlist>}]}
111-1 enable surveillance_vlan
Description
This command is used to enable surveillance VLAN globally. To enable the surveillance VLAN, a
name must be assigned to the sureveillance VLAN, and there must be an existing static 802.1Q
VLAN. To change the surveillance VLAN ID, the surveillance VLAN function has to be disabled
and then re-issue the enable command.
Format
enable surveillance_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
Parameters
<vlan_name 32> - Specifies the name of surveillance VLAN.
vlanid - Specifies the ID of surveillance VLAN.
<vlanid 1-4094> - Enter the ID of surveillance VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable a surveillance VLAN with the name “v2”:
DGS-3620-28PC:admin#enable surveillance_vlan v2
Command: enable surveillance_vlan v2
Success.
DGS-3620-28PC:admin#

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English