D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
78
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the authentication parameters:
DGS-3620-28PC:admin# show authen parameter
Command: show authen parameter
Response Timeout : 60 seconds
User Attempts : 9
DGS-3620-28PC:admin#
4-27 enable admin
Description
This command is used to promote the "user" privilege level to "admin" level. When the user enters
this command, the authentication method RADIUS, TACACS, XTACAS, TACACS+, user-defined
server groups, local enable, or none will be used to authenticate the user. Because TACACS,
XTACACS and RADIUS don't support the enable function by themselves, if a user wants to use
either one of these three protocols to enable authentication, the user must create a special
account on the server host first, which has a username enable and then configure its password as
the enable password to support the "enable" function. This command cannot be used when
authentication policy is disabled.
Format
enable admin
Parameters
None.
Restrictions
None.
Example
To enable administrator lever privilege:
DGS-3620-28PC:admin# enable admin
Password:********

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English