EasyManuals Logo
Home>D-Link>Switch>xStack DGS-3620 Series

D-Link xStack DGS-3620 Series User Manual

D-Link xStack DGS-3620 Series
1371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #459 background imageLoading...
Page #459 background image
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
454
Chapter 28
Distance Vector
Multicast Routing Protocol
(DVMRP) Commands
config dvmrp [ipif <ipif_name 12> | all] {metric <value 1-31> | probe <sec 1-65535> |
neighbor_timeout <sec 1-65535> | state [enable | disable]}(1)
enable dvmrp
disable dvmrp
show dvmrp {ipif <ipif_name 12>}
show dvmrp neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
show dvmrp nexthop {ipaddress <network_address> | ipif <ipif_name 12>}
show dvmrp routing_table {ipaddress <network_address>}
28-1 config dvmrp
Description
This command is used to configure DVMRP configurations.
Format
config dvmrp [ipif <ipif_name 12> | all] {metric <value 1-31> | probe <sec 1-65535> |
neighbor_timeout <sec 1-65535> | state [enable | disable]}(1)
Parameters
ipif - Specifies the IP interface name used.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the IP interfaces will be used.
metric - (Optional) Allows the assignment of a DVMRP route cost to the above IP interface. A
DVMRP route cost is a relative number that represents the real cost of using this route in the
construction of a multicast delivery tree. It is similar to, but not defined as, the hop count in
RIP.
<value 1-31> - Enter the metric value used here. This value must be between 1 and 31. The
default value is 1.
probe - (Optional) Specifies the time in seconds between the DVMRP Probe message
transmissions.
<sec 1-65535> - Enter the probe value used here. This value must be between 1 and 65535
seconds. The default value is 10 seconds.
neighbor_timeout - (Optional) Specifies the time period for DVMRP will hold Neithbor Router
reports before issuing poison route messages.
<sec 1-65535> - Enter the neighbor timeout value used here. This value must be between 1
and 65535 seconds. The default value is 35 seconds.
state - (Optional) Specifies the DVMRP state of the IP interface.
enable - Specifies that DVMRP of the specified IP interface will be enabled.
disable - Specifies that DVMRP of the specified IP interface will be disabled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link xStack DGS-3620 Series and is the answer not in the manual?

D-Link xStack DGS-3620 Series Specifications

General IconGeneral
BrandD-Link
ModelxStack DGS-3620 Series
CategorySwitch
LanguageEnglish

Related product manuals