D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
563
Chapter 46 IGMP Snooping
Multicast (ISM) VLAN
Commands
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority [<value
0-7> | none] {replace_priority}}
config igmp_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>] | tag_member_port <portlist>] | state
[enable | disable] | replace_source_ip [<ipaddr> | none] | remap_priority [<value 0-7> | none]
{replace_priority}}(1)
create igmp_snooping multicast_vlan_group_profile <profile_name 1-32>
config igmp_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcast_address_list>
delete igmp_snooping multicast_vlan_group_profile [profile_name <profile_name 1-32> | all]
show igmp_snooping multicast_vlan_group_profile {<profile_name 1-32>}
config igmp_snooping multicast_vlan_group <vlan_name 32> [add | delete] profile_name
<profile_name 1-32>
show igmp_snooping multicast_vlan_group {<vlan_name 32>}
delete igmp_snooping multicast_vlan <vlan_name 32>
enable igmp_snooping multicast_vlan
disable igmp_snooping multicast_vlan
show igmp_snooping multicast_vlan {<vlan_name 32>}
config igmp_snooping multicast_vlan forward_unmatched [disable | enable]
config igmp_snooping multicast_vlan auto_assign_vlan [enable | disable]
46-1 create igmp_snooping multicast_vlan
Description
This command is used to create an IGMP snooping multicast VLAN and implements relevant
parameters as specified. More than one multicast VLAN can be configured. Newly created IGMP
snooping multicast VLANs must use a unique VLAN ID and name, i.e. they cannot use the VLAN
ID or name of any existing 802.1Q VLAN. Also keep in mind the following conditions: multicast
VLANs cannot be configured or displayed using 802.1Q VLAN commands and the multicast VLAN
snooping function co-exists with the 802.1Q VLAN snooping function.
Format
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority
[<value 0-7> | none] {replace_priority}}
Parameters
<vlan_name 32> - Enter the name of the multicast VLAN to be created. Each multicast VLAN is
given a name that can be up to 32 characters.
<vlanid 2-4094> - Enter the VLAN ID of the multicast VLAN to be created. The range is from 2 to
4094.
remap_priority - (Optional) Specifies the remap priority that will be used.
<value 0-7> - Enter the remap priority (0 to 7) to be associated with the data traffic to be

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English