D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
48
Format
config radius delete <server_index 1-3>
Parameters
<server_index 1-3> - Enter the RADIUS server index. The range is from 1 to 3.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete a RADIUS server:
DGS-3620-28PC:admin#config radius delete 1
Command: config radius delete 1
Success.
DGS-3620-28PC:admin#
3-23 config radius
Description
This command is used to configure a RADIUS server.
Format
config radius <server_index 1-3> {ipaddress [<server_ip> |<ipv6addr>] | [key <password
32> | encryption_key <password 56>] | auth_port [<udp_port_number 1-65535> | default] |
acct_port [<udp_port_number 1-65535> | default] | timeout [<sec 1-255> | default] |
retransmit [<int 1-20> | default]}
Parameters
<server_index 1-3> - Enter the RADIUS server index.
ipaddress - Specifies the IP address of the RADIUS server.
<server_ip> - Enter the RADIUS server IP address here.
<ipv6addr> - Enter the IPv6 address here.
key - Specifies the key pre-negotiated between the switch and the RADIUS server. It is used to
encrypt user’s authentication data before being transmitted over the Internet. The maximum
length of the key is 32.
<passwd 32> - Enter the key pre-negotiated between the switch and the RADIUS server. It is
used to encrypt user’s authentication data before being transmitted over the Internet. The
maximum length of the key is 32.
encryption_key - (Optional) Specifies the key pre-negotiated between the switch and the
RADIUS server. It is used to encrypt the user’s authentication data before being transmitted
over the Internet.
<password 56> - Enter the enryption key.
auth_port - Specifies the UDP port number which is used to transmit RADIUS authentication
data between the switch and the RADIUS server. The default is 1812.

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English