D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
820
Chapter 72 Multicast Listener
Discovery (MLD) Commands
config mld [ipif <ipif_name 12> | all] {query_interval <sec 1-31744> | max_response_time <sec 1-
25> | robustness_variable <value 2-7> | last_listener_query_interval <sec 1-25> | version
<value 1-2> | state [enable | disable]} (1)
show mld {ipif <ipif_name 12>}
show mld group {ipif <ipif_name 12> | group <ipv6addr>}
72-1 config mld
Description
This command is used to configure MLD on the Switch.
Format
config mld [ipif <ipif_name 12> | all] {query_interval <sec 1-31744> | max_response_time
<sec 1-25> | robustness_variable <value 2-7> | last_listener_query_interval <sec 1-25> |
version <value 1-2> | state [enable | disable]} (1)
Parameters
ipif - Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all - Specifies that all the IP interfaces will be used.
query_interval - (Optional) Specifies the time in seconds between the general query
transmissions.
<sec 1-31744> - Enter the general query interval value used here. This value must be
between 1 and 31744 seconds. The default value is 125 seconds.
max_response_time - (Optional) Specifies the maximum time in seconds to wait for reports from
listeners.
<sec 1-25> - Enter the maximum response time value used here. The value must be between
1 and 25 seconds. The default value is 10 seconds.
robustness_variable - (Optional) Specifies the permitted packet loss that guarantees the MLD.
<value 2-7> - Enter the robustness variable value used here. This value must be between 2
and 7. The default value is 2.
last_listener_query_interval - (Optional) Specifies the maximum response time inserted into the
Multicast address specific query sent in response to 'done group' messages. This is also the
amount of time between Multicast address specific query messages.
<sec 1-25> - Enter the last listener query interval value used here. This value must be
between 1 and 25 seconds. The default value is 1 second.
version - (Optional) Specifies the MLD version number.
<value 1-2> - Enter the MLD version number used here. This number must be between 1 and
2. The default value is 2.
state - (Optional) Specifies the MLD state for the specified route interface.
enable - Specifies that the MLD state for the specified interface will be enabled.
disable - Specifies that the MLD state for the specified interface will be disabled.

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English