Datalogic PowerScan PD9530 User Manual

Enter/Exit Programming Mode
Product Reference Guide 225
PBT9500-ONLY FEATURES
The features in this section are valid only for PBT9500 Bluetooth models.
Also reference the Setup section for instructions on "Linking the Reader,"
starting on page 19.
BLUETOOTH SECURITY FEATURES
On the Bluetooth system, it is possible to set a (configurable) PIN code to
authenticate/connect Bluetooth devices, and encrypt the data.
The Bluetooth PIN code can be enabled and configured by reading the bar
codes in the following sections.
If you are using a Bluetooth scanner directly connected to a host through a
Bluetooth dongle, verify that the scanner and the Bluetooth driver used by
the dongle share the same PIN code and the same security level. Otherwise
the connection cannot be established.
Follow these steps to set the PIN code for a scanner:
1. Enable Bluetooth Security Mode by scanning the “Enable” bar code
below.
2. Sel
ect a PIN code length of either 4 or 16 characters by scanning the
ap
propriate bar code in "Select PIN Code Length" on page 226.
3
. Scan the relevant bar code from "Set PIN Code" on page 22
7, then scan
the desired alphanumeric characters from the key
pad in Appendix D,
Keypad to set the PIN code.
See page 306 in “References” for more detailed information and examples
for this feature.

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g