Datalogic PowerScan PD9530 User Manual

Enter/Exit Programming Mode
Product Reference Guide 259
Set String Terminator
Sets the terminator of the predefined strings.
$CPWEF
Set String Terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from th
e Alphanumeric charac-
ters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII representation
of the desired characte
rs. If less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT ba
r co
de again.
Make a mistake? Scan the CANCEL bar code to abort and
not save
the entry string. You can then start again at the
beginning.
~
CANCEL

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g