Datalogic PowerScan PD9530 User Manual

Enter/Exit Programming Mode
Product Reference Guide 267
Lower Case
This function enables/disables the capability to use the SHIFT key to switch
to Lower Case (alphanumeric) mode. When enabled, the indication in the
upper right corner of display is ‘ab’.
$CPWSA00\r
Disable Lower Case
DEFAULT
$CPWSA01\r
Enable Lower Case
SET FUNCTION KEY LABELS
Set F1 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
th
e Fu
nction Key below it.
$CPWSB
Set F1 label
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed
by 8 digits from the
Appendix D, Key-
pad
. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code again.
Set F2 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
th
e Fu
nction Key below it.
$CPWSC
Set F2 label
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed
by 8 digits from the
Appendix D, Key-
pad
. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code again.

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g