Datalogic PowerScan PD9530 User Manual

Enter/Exit Programming Mode
240 PowerScan™ PD9530/PBT9500/PM9500
COMPATIBILITY WITH PM8500
Compatibility Mode
Powerscan PM9500 offers a limited set of features compatible with the pre-
vious PM8500 family. To access those features, you have to program the
system thro
ugh the Compatible Mode parameter.
When in normal mode, the same parameter can be used to configure the
communication speed.
You must read the barcode "Restore Custom Defaults" on
page 18 when switching from normal mode to compatible mode, or
vice-versa.
Changing from Normal to Compatible Mode
PM9500 Handheld
1. With the PM9500, read the Compatible Mode (0) bar code below.
2. Now you can link your PM9500 with a BC8xxx as if it were a PM8500,
as
signing an address to the reader and performing a Join or Bind (see
the Set Radio Address and Bind commands in the PM8500 QRG).
$CSTCP00\r
Compatible Mode (0)
$CSTCP01\r
Normal Mode: Low Speed (1)
$CSTCP02\r
Normal Mode: Intermediate Speed (2)
$CSTCP03\r
Normal Mode: High Speed (3)
DEFAULT
When the PM9500 is in Compatible Mode, some newer features
(such as communication speed programming) will not be available.

Datalogic PowerScan PD9530 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Tilt reading angle	0 - 360 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
Standard interfaces	RS-232, USB, Keyboard wedge
Connectivity technology	Wired
Product color	Black, Yellow
International Protection (IP) code	IP65
Input voltage	5 V
Power consumption	350 mA
Power source type	DC
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Cables included	No

Weight and Dimensions

Depth	110 mm
Width	74 mm
Height	212 mm
Weight	330 g