4.3 Installation
4.3.1 Installing Modules in a Control Box
A PLC has to be installed in a closed control box. In order to ensure that the PLC radiates heat normally, the
space between the PLC and the control box must be larger than 50 millimeters.
AS200 / AS300
AS100
Keep the PLC away from high-voltage equipment, high-voltage wires, and high-voltage motors.
In order to prevent the PLC from overheating, please do not install the PLC vertically on the bottom or top
of the control box.
Please install the PLC horizontally in the control box, as shown above.
If you intend to increase the number of modules, you must leave some space for installing the modules in
the control box.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
Need help?
General
