12.3.7.2 ERROR LED Indicators Blinking Every 0.5 Seconds
Warning type of error codes:
Error
Description Solution
16#1506
Remote module had been stopped.
This error code should work with AS Series Remote
Module Setting in ISPSoft. When this error code shows
up, it indicates the remote module had been stopped:
Master Disconnected, Master Reconnected, IO Module
Alarm, or IO Module Timeout. Check and clear the
problem and then power-off and then power-on the
remote module to refresh its state. Refer to section 9.4.3
in AS Series Module Manual for more details.
12.3.7.3 ERROR LED Indicators Blinking Every 0.5 Seconds
Warning type of error codes:
Error
Description Solution
16#1500 Remote module communication timeout Make sure the communication cable is well connected
16#1502 Incorrect parameters
Check the parameter in HWCONFIG. Download the
16#1503
Remote extension module communication
timeout
Make sure the communication cable is well connected
and the module is properly connected to the CPU
module and turn the modules on again.
16#1505
The actual placement of the extension
modules is NOT the same as it is set.
Check if the parameter in HWCONFIG is the same as
16#1604
Extension module communication
timeout
1. Make sure the module is properly connected to the
CPU module and turn the modules on again.
2. If the problem persists, contact the local authorized
12.3.7.4 ERROR LED Indicators Blinking Every 0.2 Seconds
This happens when the 24 VDC power supply for the remote module is not sufficient. Check the power supply. If the
power supply is normal, remove the extension module from the CPU module and then check if the SCM remote module
is out of order. Error codes:
Error
Description Solution
16#1303
24VDC power supply is not sufficient and
then recovered from low-voltage for less
Check whether the 24 V power supply to the module is
normal.
12.3.8
Troubleshooting for AS01DNET Modules
Refer to sections 12.4.9 and 12.4.10 for more details.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com