Delta AS132P-A User Manual

8.2.11 Ethernet Port Advance Setting – Email
Email
table is for users to set the email-related functions. The email will be sent to the set email address after the
email function is enabled. Total four groups of email sending conditions and four groups of email addresses can be
set.
 Select
Email Function Enable
to enable the function and then start setting the following parameters.
 Set an IP address of SMTP server. Set the COM port of SMTP server at the COM port and set the sender’s
email box at local email address. Type a mail subject as the start of the subject of every email.
 Select
Account identification
checkbox to enable the function. Users can set to authenticate themselves with
a user name and a password before logging in to an SMTP server.
 Type the target email address of a receiver.
Type a trigger name in
Trigger Name box
and a minimum interval in
Trigger Min Cycle
in the
Trigger Setting
table.
And then select a trigger condition on the drop-down list. When the sending condition is met, the system will send an
email every a period of time. But the same email will not be sent again within the set interval.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

Delta AS132P-A Specifications

General

Brand	Delta
Model	AS132P-A
Category	Network Hardware
Language	English