IFD9503
The IFD9503 gateway converts
CANopen to Modbus, and connects a
device (with an RS-232 or RS-485
interface) that conforms to the
standard Modbus protocol to a
CANopen network. You can connect
up to 15 devices.
DVPCP02-H2
The CANopen slave module is
connected to the right side of an EH2
series PLC. It can connect the EH2
series PLC to a CANopen network.
IFD6503
This analyzes CANopen network data,
and has ports both ends for a CAN
interface and a USB interface. Use it to
monitor CAN network data, or allow
CAN nodes to transmit the data. The
product is used with the Netview
Builder software.
ASD-A2-xxxx-M
servo driver
This servo driver has a built-in
CANopen interface. It controls
positioning, speed, and torque.
VFD-
C2000/CP2000/C200
series AC motor drives
This AC motor drive has a built-in
CANopen function, and controls
positioning, speed, and torque. For the
C2000/CP2000 series AC motor
drives, you must purchase a CMC-
COP01 to provide the CAN interface.
Only the C200 series AC motor drive
has the built-in CANopen interface.
VFD-EC series AC motor
drive
The EC series AC motor drive has a
built-in CANopen interface. It controls
speed and torque.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
Need help?
General
