After setting up the parameters, click on the icon toolbar to have the system in the online mode. Then click
to download the settings to the PLC. And then click to record data.
Note: From here you can also follow Operation B to complete the recording and saving.
When the recording is done, click the uploade button to update the data for later viewing.
Click on the icon toolbar to export the data to your computer for future use.
Click on the icon toolbar or use SM and SR to save the data to the SD Card installed on the PLC.
Operation B
You can also use SM flags or SR registors to complete the data recording, data saving or set to store data on a SD card
permanently. See the example below for reference.
Example:
Check if the flag SM457 is ON. If the flag SM457 is ON, it indicates the valid recorded parameters are downloaded in
data logger. And that means the operation A is done correctly.
Use inputs to enable/disable or set the flag SM454 to ON for the PLC to start recording. If you need to store data on
a SD card, set SR902=16#5AA5.
When SM455 is ON or when the quantity of data has met the value set in SR900 (32-bit value), the system start
saving data on a SD card.
NOTE: While sending data to the SD card for storage, the PLC needs a period of undisturbing time, approximately
tens of milliseconds. During this period, the PLC is not allowed to execute interrupts. Make sure the PLC is NOT
executing any interrupts, especially the external input ones before starting to send data to the SD card for storage.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
Need help?
General
