Clock setup
This function is used to set the clock time.
To set the clock, access the "SET" page in the menu.
SETTING THE TIME
Holding switch (1Fig. 9), pressed in position B
“
“ for 3 seconds in this menu page gives access
to the setup mode.
On entering this mode, the message “AM” will flash;
if you press switch (1Fig. 9), in position B “ ” the
message “PM” flashes; if you press switch
(1Fig. 9), in position B “ ” the mode will go back to
previous setting (if it is 00:00, when toggling from
“AM” to “PM”, 12:00 will be displayed).
- Pressing switch (1Fig. 9), in position A " " gives
access to the hour setting mode; hours start to
flash. Each time you press the switch in position
B "
", the count will increase cyclically in steps
of one hour If the switch is held pressed in
position B “ ” the count will increase cyclically
in steps of one hour every second (when the
switch is held depressed, the hours do not flash).
- Pressing switch (1Fig. 9), in position A " " gives
access to the minutes setting mode; hours start
to flash. Each time you press the switch in
position B " ", the count will increase cyclically
in steps of one minute If you hold the switch
down in position B “ ”, the count will increase
cyclically in steps of 1 minute every second. If the
switch is held depressed in position B " " for
over 5 seconds, minutes will increase by 1
minute every 100 ms (while the switch is held
depressed in position B " ", seconds will not
flash).
- Pressing the switch in position A " ", exits setup
mode and the new time is displayed.
53