Headlight “smart” switch-off
This function helps reduce battery use by
automatically switching off the headlight. The device
is enabled in three instances:
- 1) When the key is turned from OFF to ON and
the engine is not started within 60 seconds, the
headlight is turned off and will be turned back on
next time you start the engine.
- in case 2, after the vehicle has been running with
the headlights on and the engine is stopped using
the RUN-STOP button on the RH switch.
In this case, 60 seconds after stopping the
engine, the headlight is turned off and will be
turned back on next time you start the engine.
- 3) While starting up the engine, the headlight is
turned off and back on as soon as the engine is
started.
Headlight “smart” switch-on
This function allows programmed activation of the
headlight even with the motorcycle off (Key-Off). The
instrument panel stays active for 60 seconds soon
after Key-Off, and the headlight can be switched on
by pressing switch (1Fig. 9), in position A "
" or B
" ".
During these 60 seconds, each time switch (1Fig. 9),
is pressed in position A “ ” or B “ ”, the
instrument panel will activate the headlight for 30
seconds; each press of the switch will add to the
headlight activation time, up to a maximum of 6
presses (equivalent to a maximum activation time of
180 seconds).
After the first time you press switch (1Fig. 9), in
position A “
” or B “ ”, the period of 30 seconds
starts, thus switching on the headlight Further
switch-on time can be added only if you press the
switch again within these 30 seconds. If the 30
seconds have elapsed, no further multiples of 30
seconds can be added, and the instrument panel will
switch off the headlight.
To reset this function, you must perform at least one
Key-On/ Key-Off.
If the battery power is interrupted at any time while
this function is active, when power is restored, the
61
To Next Page
Loading...
Need help?
General
