Assembly
6 Requirements
The room chosen for installation must satisfy the
following requirements:
– Closed, dry room
– Clean, level and sufficiently stable subsurface
– There should be no large interference fields
present (e.g. strong magnetic fields) that could
interfere with correct operation of the unit.
– The required ambient conditions are satisfied
(refer to the "Technical Data").
7 Installation
7.1 Establishing the electrical
connections
The connection ports are located in the recess
on the rear of the unit.
Requirements:
ü
Correctly installed power outlet in the vicinity of
the unit (max. length of mains cable 3 m)
ü
The plug connection of the power supply is
freely accessible so that it can be quickly dis-
connected in the event of danger.
ü
Mains voltage must match the information
shown on the type plate of the power supply
unit
ü
The supply voltage of the power supply unit
matches the data on the type plate.
❯
Plug in the connecting plug of the connecting
cable into the connecting socket of the unit.
❯
Fit the correct country-specific adapter.
❯
Plug the mains plug into the power outlet.
Assembly
9000-615-28L02 1903V004 17
EN
To Next Page
Loading...
Need help?
General
