cally. If necessary the process can be stopped
earlier by pressing the button again.
Inserting the fluid container
❯
Check whether the fluid container is full. If nec-
essary top up the fluid container to the upper
marking with lukewarm water (approx. 30 °C).
❯
Insert the fluid container vertically in the correct
position into the unit and press downwards
until you feel it lock into position.
Attaching the handpieces
Paro handpiece:
❯
Attach the Paro handpiece to the hose con-
nection.
❯
Check the ring cover for signs of damage
before using it.
Scaler handpiece:
❯
Attach the Scaler handpiece to the hose
connection.
Inserting/changing instruments
CAUTION
If an attempt is made to perform a
treatment with a damaged or worn
instrument, this can cause injury and
may result in an unsuccessful treat-
ment.
❯
Worn or bent instruments should be
replaced immediately and not reused!
❯
Check the Paro handpiece instruments
for signs of discolouration or rough-
ness in the region where they are held
in the chuck; if necessary dispose of
them.
The tool kit cover of the instrument is
used as a torque wrench for tightening
the union nut of the instrument chuck.
❯
Select a suitable instrument for the corre-
sponding treatment.
Instrument for Paro handpiece:
❯
Loosen the union nut approximately a
1/4 turn.
❯
Insert the instrument as far as it will go into
the instrument chuck.
Usage
34 9000-615-28L02 1903V004
EN
To Next Page
Loading...
Need help?
General
