Troubleshooting
16 Tips for operators and service technicians
Prior to working on the device or in case of danger, disconnect it from the mains (e. g. pull the
mains plug).
Any repairs exceeding routine maintenance may only be carried out by qualified personnel or our
service.
Error Possible cause Remedy
Unit does not start
Unit is not switched on.
❯
Touch the On / Standby but-
ton for at least 2 seconds.
The flexible foot switch cable is
not connected.
❯
Connect the flexible foot
switch cable.
The flexible foot switch is defec-
tive.
❯
Replace the flexible foot
switch and send in the defec-
tive flexible foot switch for
repairs.
Handpiece is defective.
❯
Replace the handpiece and
send in the defective hand-
piece for repairs.
The resonating body in the Paro
handpiece is defective.
❯
Refer to Troubleshooting,
point 12.
Unit runs with interruptions in
wireless operation or wireless
operation with the flexible foot
switch is not possible.
The battery in the flexible foot
switch is empty.
❯
Check battery performance
and insert a new battery if
necessary.
Interference caused by external
wireless signals.
❯
Operate the flexible foot
switch using the foot switch
cable.
The wireless module in the flexi-
ble foot switch is defective.
❯
Operate the flexible foot
switch using the foot switch
cable or call a Service Techni-
cian.
The wireless module in the basic
unit is defective.
❯
Operate the flexible foot
switch using the foot switch
cable or call a Service Techni-
cian.
Pairing of the flexible foot switch
has not been performed.
❯
Before using it for the first
time, pairing (i.e. synchronisa-
tion/coupling) must be per-
formed between the flexible
foot switch and the unit.
Troubleshooting
70 9000-615-28L02 1903V004
EN
To Next Page
Loading...
Need help?
General
