FLEX-6000 Signature Series – Maestro User Guide
Copyright 2024 FlexRadio, Inc. All Rights Reserved. | Page 94
20.4 HOW TO CONFIGURE THE AUDIO CONTROLS FOR PHONE MODES
Connect a suitable microphone to the RJ45 MIC1 connector or the 1/8
th
inch TRS MIC2 connector
on the back panel of the Maestro. Press the Maestro TX Menu button to bring up the TX Menu,
then select the appropriate microphone from the microphone list at the left side of the menu. See
section 36.6.1, Audio Modes Transmitter Menu for a description of the inputs. See section 20.4.7,
DAX TX Channel and Microphone Interaction for information about coordinating DAX TX channel
usage with microphones.
Note: With multiFLEX, the microphone PTT (and all other hardware PTT sources) will use the
Local PTT Station to transmit (see section 33.15, multiFlex Tab)
20.4.1 Setting the Transmit Filter Bandwidth
The bandwidth of a single sideband transmission is determined by the Low and High bandwidth
controls found on the TX Menu. The bandwidth is adjustable up to 10 KHz in 50 Hz steps. The
transmit bandwidth is double for symmetric sideband modes such as AM.
Each Slice Receiver can display an input level meter. Tap the Slice Receiver meter display to cycle
through the available meters. There are two indicator components of the microphone or input
Level meter that show the actual audio input level. The leftmost component is a solid bar
To Next Page
Loading...
Need help?
General
