FLEX-6000 Signature Series – Maestro User Guide
Copyright 2024 FlexRadio, Inc. All Rights Reserved. | Page 51
Band Selection
Direct Frequency Entry
RX filter presets
TNF
FDX
DSP functions such as WNB, NB, NR, ANF, APF, AGC Speed, and Threshold.
Record and Playback of received and transmitted signals
When you are ready to return to the main control screen, you can either tap on the upper section
of the screen or press and hold the tuning knob for that slice.
9.5.5 Exiting SmartControl
To exit SmartControl mode, simply tap the EXIT button on the lower left corner of the main screen.
This will return you to the “Select Radio” screen.
NOTE: If you wish to turn your Maestro OFF and have it return in SmartControl mode, you do
not need to tap “EXIT.” Simply turn the Maestro OFF. The next time you power up the
Maestro, it will return to SmartControl mode.
9.5.6 Changing to a Different Radio in Your Network
If you have multiple radios in your network and want to change which radio to control with
SmartControl, click the “Station” drop-down menu in the center near the bottom of the screen, and
select a different radio to control. It may take a few seconds to negotiate the new connection. If it
fails to negotiate a connection, simply return to the Radio Chooser and connect again to the desired
radio as a SmartControl.
To Next Page
Loading...
Need help?
General
