FLEX-6000 Signature Series – Maestro User Guide
Copyright 2024 FlexRadio, Inc. All Rights Reserved. | Page 87
19.1 HOW TO OPERATE CW IN SPLIT MODE
Many DXpeditions prefer to operate in split mode, in which they transmit on one frequency but
listen on another, up or down a few kilohertz. To do this with Maestro, the A Slice must be set to
the DX station’s transmitting frequency, and the B Slice must be inactive. Press the B slice TX
button. The B Slice will become active, its frequency will be set to a value 1 KHz higher than the A
Slice Receiver’s frequency and the transmitter control will move to the B Slice. Your Panadapter
display should look similar to this:
If you prefer, you can use the Slice audio controls to pan the Slice audio so one receiver is in your
left ear and the other is in your right ear. Touch and drag the L/R control in the Slice Receiver
Menu to move that Slice Receiver’s audio to the left or right ear.
To leave split mode and disable the transmitter, press the B-RX button to remove the B slice. Press
the A-TX button to restore the transmitter to the A slice receiver
If you have configured one of the function buttons (F1 – F6) as a Split button (see section 33.4,
Function F1-F6 Tab), and if the B slice is inactive, then a single press of the function button will
create the split configuration. The B slice will control the transmitter. Pressing the button a second
time will disable the B slice and return the transmitter to the A slice receiver.
To Next Page
Loading...
Need help?
General
