Common Service Settings
103
Tools
5
O: Available
X: Not available
Millimeters/Inches
Select whether the unit of measure displayed on the screen is millimeters or inches.
Keyboard Input Restriction
Select whether to restrict the display of the virtual keyboard on the machine. To prevent
characters being garbled when switched from one character set to another, you can restrict
the input to ASCII characters only. If you select [On (Standard ASCII only)], the displayed
keyboard shows ASCII characters only.
Operation of Up/Down Buttons
Select whether or not there is a continuous scrolling effect when the scroll buttons are held
down.
Disable Fast Scrolling
Holding down the scroll buttons does not scroll.
Enable Fast Scrolling
Holding down the scroll buttons causes continuous scrolling.
Display Consumables Screen
Set whether the machine displays the parts status when parts need to be replaced.
Off
Does not display the consumable status screen.
When power is switched on
Status is displayed at startup.
When Auto Clear is activated
Status is displayed when Auto Clear is executed.
8K OOOXXXXXXXXXXXX
100 x 148 mm XXXXOXXXXXXXXXX
4 x 6" XXXXXXXXXOOXXXX
4 x 6" XXXXXXXXXXXXXXO
5 x 7" XXXXXXXXXXOXXXX
Envelope 120 x 235
mm
XXXXOXXXXXXXXXX
Envelope (104.8 x 241.3
mm)
XXXXXXXXXOXXXXO
Envelope (98.4 x 190.5
mm)
XXXXXXXXXOXXXXO
Envelope (162 x 229
mm)
XXXXXXXXXOXXXXO
Paper Size Group AB Series (8 K/16 K) AB Series (8.5 x 13”/8.5 x 14”) Inch Series
Original Position
Size/Orientation
Document Glass
Document Feeder
Tray 1-4 (except for TTM)
Tray 3, 4 (TTM)
Tray 5 (Bypass)
Document Glass
Document Feeder
Tray 1-4 (except for TTM)
Tray 3, 4 (TTM)
Tray 5 (Bypass)
Document Glass
Document Feeder
Tray 1-4 (except for TTM)
Tray 3, 4 (TTM)
Tray 5 (Bypass)
To Next Page
Loading...
Need help?
General
