1 Before Using the Machine
18
Before Using the Machine
1
Energy Saver Mode
The machine is installed with a Energy Saver feature that will automatically cut off the
electricity to the machine if no copy or print data is received for a certain duration.
The Energy Saver feature has two modes: [Low Power mode] and [Sleep mode].
The machine enters the Low Power mode after the preset time has elapsed if the
machine is left unused for a fixed period of time.
The machine then enters the Sleep mode if a further preset time elapses.
îš„Low Power Mode
In this mode, the power to the control panel and fuser unit is lowered to save power.
The touch screen goes out, and the <Energy Saver> button on the control panel lights.
To use the machine, press the <Energy Saver> button. The <Energy Saver> button
goes out to indicate that the Energy Saver feature is cancelled.
îš„Sleep Mode
In this mode, the power is lowered more than in the Low Power mode.
The touch screen goes out, and the <Energy Saver> button on the control panel lights.
To use the machine, press the <Energy Saver> button. The <Energy Saver> button
goes out to indicate that the Energy Saver feature is cancelled.
Changing the Energy Saver Mode Change Interval
The procedure for setting the Energy Saver feature is as follows.
To activate the Energy Saver feature, set both the times until the activation of Low
Power Mode and Sleep Mode.
Note • The time to activation of Low Power Mode and Sleep Mode can each be specified in 1
minute increments, from 2 to 60 minutes.
1
Press the <Log In/Out> button.
2
Enter the system administrator’s
user ID with the numeric keypad or
the keyboard displayed, and select
[Enter].
When a passcode is required,
select [Next Input] and enter the
system administrator’s passcode,
then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
123
456
789
0#
C
<Log In/Out>
button
To Next Page
Loading...
Need help?
General
