15 Appendix
484
Appendix
15
z
When [Receiving Buffer - LPD] is set to [Off]
While the machine is receiving a print request from a computer, the machine cannot
accept any print requests from other computers.
z
When a computer's IP address or a computer name is changed
When a computer's IP address or a computer name is changed, queries and cancel
processes from the machine will not be performed correctly. Switch the machine off
and on when there is no print data in the receiving buffer.
Note • Canceling print jobs or forcing the machine to print the remaining jobs in the receiving buffer
can be operated from the control panel on the machine. For information on the operation,
refer to "9 Job Status" in the User Guide.
Notes and Restrictions for Using EtherTalk
The following are the notes and restrictions for using EtherTalk.
Printer Name
Printer names used to be identified by clients are set not to duplicate each other. When
assigning a new printer name, if the same printer name has already existed on the
network, the system automatically change the printer name on startup.
<Rules for changing printer name>
Printer names are changed according to the following rules:
z
Names of 31 characters or less
Add a number to the end of the printer name. If the same printer name with the
number added has still existed on the network, increase the added number by 1.
z
Names of 32 characters
Change the last character of the printer name to a number. If the same printer name
with the last character changed has still existed on the network, increase the
changed number by 1.
If the printer name has been changed, when browsing [Protocols] on the [Properties]
tab of CentreWare Internet Services, the previous printer name set before the
change is displayed. However, the changed printer name is registered on the
network, clients can browse the printer using the changed printer name. If the printer
is turned off and then on while the printer name has been changed, the printer is
activated with the changed printer name. If the same printer name has already
existed on the network, the printer name will be changed according to the rules
described above on startup.
Assign a printer name not to duplicate to other printer names on the network.
Zone Name
Zone names can be set in [Protocols] on the [Properties] tab of CentreWare Internet
Services. However, if the zone name set does not exist on the network to which the
printer is connected, the zone name is automatically set as default. To set a zone
name, use the zone name that has already existed on the network.
To Next Page
Loading...
Need help?
General
