15 Appendix
472
Appendix
15
Activity Report
You can use activity reports to check whether a transmission is successfully completed
or not. In the report, a remote terminal name and a result or a status of each operation
are recorded by outgoing and incoming transmission.
For information about the activity report, refer to "Print Reports" (P.59).
Item Description
No. The serial numbers for transmissions is shown.
Doc. Job numbers that the machine automatically assigned to
documents when the documents were received.
Remote Station Information on recipient to which transmission is made is
recorded in the following order of priority.
îš„Transmitting (speed dialing)
cRecipient
dRemote terminal name
eG3 ID (including spaces)
fTel. No.
gCommunication mode EC (or G3, SG3)
îš„Transmitting (when all digits are dialed)
cRemote terminal name
dG3 ID (including spaces)
eTel. No.
fCommunication mode EC (or G3, SG3)
îš„Receiving
cRemote terminal name
dG3 ID (including spaces)
eCommunication mode EC (or G3, SG3)
Note • You can set the number of character digits displayed for
the recipient. For details on setting up, see "Recipient
on Activity Report" (P.97). The factory set default
displays the first 40 digits.
Start Time The date and time that the communication began are shown.
In Batch Send, the start time of the transmission for each doc-
ument is recorded.
Duration The communication length is indicated. In Batch Send, the
length of time taken for a transmission for each document is
recorded.
Pages "-" is indicated when the number of pages is 0.
îš„Transmitting
The number printed on the left side of the slash "/" indicates
the number of pages that were successfully transmitted. The
number printed on the right side of the slash "/" indicates the
number of total pages. In Batch Send, the number of total
pages is not shown.
îš„Receiving/Polling
The number of pages that the machine successfully received
is shown.
Mode The mode used for the communication is shown here.
There are three modes; G3, EC, and SG3 (Super G3). (This
field is blank if a mode other than these was used.)
To Next Page
Loading...
Need help?
General
