5 Tools
92
Tools
5
Alert Tone
Select the sound to be made when a fault such as a paper jam occurs, and the fault is left
unattended to.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Out of Paper Warning Tone
Select the sound to be made when a job is suspended due to running out of paper in a tray.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Low Toner Alert Tone
Select the sound to be made when the toner cartridge needs to be replaced.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Line Monitor Volume
You can relay the sound on the telephone circuit in the interval from dialing until the
connection is made through the speakers on the machine. This is convenient for using Fax
Information Services without using the telephone.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Ringing Volume
Select the sound to be made when an incoming call arrives at the machine.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Stored Programming Tone
Select the sound to be made while a stored program is registered.
You can select the volume from [Soft], [Normal], and [Loud].
It is not possible to disable this sound.
Auto Clear Alert Tone
Select the sound to be made at 5 seconds before automatically returning to the initial screen,
when the auto clear feature is enabled.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Base Tone
For a button that toggles (changes setting each time it is pressed), set the sound to be made
when in the home position. The machine makes this sound when it exits the Interrupt mode.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Screen/Button Settings
Set screens and buttons.
Screen Default
Set the features displayed on the screen that appears after turning the machine on or
canceling the Energy Saver mode.
For more information, refer to "Customizing the Control Panel" (P.20).
To Next Page
Loading...
Need help?
General
