Notes and Restrictions
481
Appendix
15
The following shows adequate image sizes:
z
A4 full-color 200dpi with standard compression : around 700 KB
z
A4 black-white 200dpi (text document) : around 25 KB
z
A4 black-white 200dpi (text & photo document) : around 200 KB
Note • The sizes described above are those for sending e-mail. The actual size may be different.
îš„Settings from CentreWare Internet Services
For settings to be performed on CentreWare Internet Services, refer to "Setting Items
Using CentreWare Internet Services" (P.197).
Important • Set [POP3 Server Check Interval] to 10 minutes or longer when connecting ISP.
Notes and Restrictions for Using SMB
The following are the notes and restrictions for using SMB.
Configuration on the Machine
z
IP addresses are managed throughout the system as a whole. The configuration
should be performed only after consulting with your network administrator.
z
Subnet Mask and Gateway addresses may be necessary depending on the network
environment. Confirm with the network administrator and set up the necessary items.
z
When the port status is set to [Enable], it sometimes automatically switches to
[Disable] if the machine has insufficient memory. If this happens, either set an
unused port to [Disable], or adjust the assigned memory size.
z
Adjust the receiving buffer [SMB] size according to usage. When the receiving buffer
[SMB] size is smaller than the transmitted data, the machine may not be able to
receive the data.
Configuration on a Computer
z
IP addresses are managed throughout the system as a whole. The configuration
should be performed only after consulting with your network administrator.
Switching Off the Power
Check the following points when switching off the machine.
z
When [Receiving Buffer - SMB] is set to [Spool to Memory].
All print data spooled within the machine memory, including the data which is being
printed is erased. The print data will not be found when the machine is powered on
again.
However, if the power was switched off immediately after a computer instructed a
print job, the job may remain on the computer. In this case, the stored data on the
computer will be printed out in order before any later instructions when the machine
is powered back on.
z
When [Receiving Buffer - SMB] is set to [Spool to Hard Disk].
All print data spooled in the machine hard disk, including the data which is being
printed is preserved. In this case, the stored data on the machine hard disk will be
printed out in order before any later instructions when the machine is powered back
on.
To Next Page
Loading...
Need help?
General
