Print Service Settings
131
Tools
5
Receiving Buffer - IPP
îš„No Spooling
Does not use spooling. While IPP print processing is being carried out for one client, data
cannot be received over the same interface from another client.
Set a value for the dedicated IPP receiving buffer memory capacity from 64 to 1,024 KB in 32
KB increments.
îš„Spool to Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer.
Specify a value within the range from 1,024 to 2,048 KB, in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port 9100 receiving buffer.
Specify a value within the range from 64 to 1,024 KB in 32 KB increments.
Delete Form
You can delete registered ESC/P-K forms.
1
Select [Delete Form].
2
Select the print mode to delete
forms.
3
Enter the form number with the
numeric keypad, and select
[Confirm].
4
Check the form name, and select [Delete Data].
îš„ESC/P
Delete ESC/P-K emulation forms.
îš„Form Number
When you select an item to be deleted, you can enter the form number. Specify a form
number from 1 to 2048.
îš„Form Name
After you enter the form number and select [Confirm], the form name matching the entered
number appears.
Other Settings
You can make other settings relating to the paper used in the printer.
Print Area
Set whether to expand the print area.
For information about the printable area, refer to "Printable Area" (P.433).
For information on the extended printable area, refer to "Extended Printable Area" (P.433).
To Next Page
Loading...
Need help?
General
