Notes and Restrictions
475
Appendix
15
Example 1)
When you select [2 sheets J 1 sheet (2-up)] for Document 1 (4 pages) and [No] for
Document 2 (2 pages), both Documents 1 and 2 are set to [No] and the number of
printed pages is calculated as follows:
z
Total pages: 4
z
2 up: 0
Example 2)
When you select [No] for Document 1 (4 pages) and [2 sheets J 1 sheet (2-up)] for
Document 2 (2 pages), both Documents 1 and 2 are set to [2 sheets J 1 sheet (2-up)]
and the number of printed pages is calculated as follows:
z
Total pages: 5
z
2 up: 5
The numbers of pages for 2in1, 4in1, and 8in1 are also calculated in the same way as
above on ApeosWare Accounting Service.
The meter on the [Billing Information] screen calculates the number of printed pages
correctly regardless of the [Multiple-up] setting.
îš„Addresses Registered on Job Flows
When an abbreviated number or address registered on Address Book has been used
for a job flow creation on the machine, any number of address change on Address Book
will not be reflected to the job flow. To send to the changed address, the address
registered on the job flow must be directly changed.
îš„Print Job Speed at Control Panel Operation
If your DocuCentre has an optional full size color UI, the process or output speed of
print jobs may be reduced if you operate the control panel or check print job status on
the [Job Status] screen while performing a print job.
Notes and Restrictions in the Interrupt Mode
If you press the <Interrupt> button while running a print job, the machine temporarily
stops printing and goes into the interrupt mode.
Note • However, if a scan job is running at the same time, the print job cannot be interrupted.
To Next Page
Loading...
Need help?
General
