Print Service Settings
129
Tools
5
Print Service Settings
In [Print Service Settings], you make settings relating to the printer feature.
When using CentreWare Internet Services, more detailed settings are possible.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
For more details, refer to "CentreWare Internet Services Settings" (P.193).
The following shows the reference section for each item.
Allocate Memory...................................................................................................................... 129
Delete Form.............................................................................................................................. 131
Other Settings........................................................................................................................... 131
1
Select [Tools].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.76).
2
Select [Print Service Settings].
3
Select the item to be set or changed.
Allocate Memory
For each interface, set the memory capacity for the receiving buffer (temporary storage
for data sent from the client).
You can change the receiving buffer capacity depending on the pattern of use and
purpose. Increasing the receiving buffer capacity may allow a client to be released
sooner from an interface.
Important • If you change the memory capacity settings, the memory is reset, and therefore data stored
in all memory areas is lost.
• It is not possible to assign more than the total memory. When the power is turned on, if the
settings exceed the available memory capacity, they are automatically adjusted by the
system.
Note • When a port is set to [Disabled], the corresponding items do not appear.
• Depending on the amount of data sent from the client, increasing the memory capacity may
not change the time taken to release the client.
PostScript Memory
Specify a value for the PostScript memory capacity from 16.00 to 96.00 MB in 0.25 MB
increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.
ESC/P-K Form Memory
Displays destination to save forms used in ESC/P-K.
If a hard disk is not installed, data can be stored in the ESC/P-K form memory. You can
specify the value within the range from 128 to 2048 KB in 32 KB increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.
To Next Page
Loading...
Need help?
General
