Fuji Xerox DocuCentre-IV 4070 User Manual

Energy Saver Mode
25
Before Using the Machine
1
Changing the Interval for Entering Energy Saver Mode
This section describes the procedures for setting Energy Saver mode.
To activate the Energy Saver, set the time to elapse until the machine enters Low
Power mode as well as the time to elapse until the machine enters Sleep mode.
Note • You can set the time to elapse until the machine enters Low Power mode and Sleep mode
from 1 to 240 minutes in 1 minute increments.
1 Press the <Log In/Out> button.
2 Enter the system administrator's user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next]
and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3 Select [Tools] on the [Services Home]
screen.
Note • When the [Services Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
4 Select [System Settings] > [Common
Service Settings] > [Machine Clock/Timers].
5 Select [Energy Saver Timers], and then
select [Change Settings].
Note • Select [ ] to display the previous screen
or [ ] to display the next screen.
123
4
56
789
0#
C
<Log In/Out> button

Fuji Xerox DocuCentre-IV 4070 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV 4070
Category	Copier
Language	English