16 Appendix
576
Appendix
16
îš„Interface-dependent
You can set a printer language for each host interface by using CentreWare Internet
Services. The machine switches to a printer language corresponding to the host
interface that received data.
Fonts
This section explains the fonts used for emulation.
Available fonts
The following fonts can be used for ESC/P-K emulation:
îš„ESC/P-K Emulation
Available outline fonts are as follows:
z
Roman
z
Sans serif
z
ShuSong
z
OCR-B
User-defined Characters
On the machine, you can use user-defined characters.
User-defined characters can be stored only in memory. Thus, they are deleted when
the machine is turned off. However, if you install the optional hard disk, the user-defined
characters are stored on the hard disk, and consequently are retained even after the
machine is turned off. The capacity of user-defined characters that can be stored on
the hard disk equals with the capacity when stored in memory.
The total capacity of memory for storing user-defined characters and other user-
defined data can be set on the control panel. This value is retained after the machine
is turned off.
User-defined characters are registered as bitmap fonts, and cannot be shared among
different printer languages.
Font Caching
To ensure hi-speed printing, outline fonts of up to a certain size are cached. Outline
fonts are converted into bitmap data temporarily and then printed. To minimize this
processing time, the processed bitmap data is saved in the memory. This process is
called font caching.
The saved bitmap data is deleted when you turn the machine off or reset it.
Output Feature
This section describes the machine's output feature.
Outputting a Pending Print Job
The printing of jobs already received by the machine can be prioritized over other jobs.
For information on prioritizing the printing of jobs already received by the machine, refer to "11 Job
Status" > "Printing Pending Jobs" in the User Guide.
To Next Page
Loading...
Need help?
General
