Installation When Using NetWare
289
Printer Environment Settings
7
Installation When Using NetWare
This section describes how to install the machine using Netware.
The following shows the reference section for each procedure.
Step 1 Preparations................................................................................................................... 289
Step 2 Configuration on the Machine ...................................................................................... 289
Step 3 Configuration on the Computer .................................................................................... 291
CentreWare Internet Services Setting Items ............................................................................ 291
Step 1 Preparations
The following items are required to set up the machine to use NetWare.
z
NetWare server
z
TCP/IP or IPX/SPX network environment
z
The Driver CD Kit (provided with the machine or option)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use NetWare on the machine.
Note • You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.291). For information on how to configure the setting using the Driver CD
Kit, refer to the manual contained in the Driver CD Kit.
Using IPX/SPX
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the NetWare port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [NetWare], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3 Select [Close] repeatedly until the [Tools] screen is displayed.
To Next Page
Loading...
Need help?
General
