Replacing Consumables
73
Maintenance
3
5 Close the finisher front cover, and then close the top transport cover of the finisher.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
remain paused.
Emptying the Hole Punch Waste Container (for Finisher-C1 or Finisher-
C1 with Booklet Maker)
When the Finisher-C1 (optional) or Finisher-C1 with Booklet Maker (optional) is
installed and the hole punch waste container becomes full, a message appears on the
touch screen. When the message appears, empty the hole punch waste container as
instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
Not doing so will cause the container to fill up before the message telling you to empty
the container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container
while the machine is off, the machine does not recognize that the container has been
emptied.
• When the machine is in Energy Saver mode, exit Energy Saver mode by pressing the
<Energy Saver> button and the <Machine Status> button on the control panel before you
empty the hole punch waste container.
• When you empty the hole punch waste container, press the <Machine Status> button and
check the current status for the hole punch waste container even when the control panel is
lit.
1 Make sure that the machine is not operating,
and open the finisher front door.
2 Pull out the hole punch waste container [R4].
3 Empty the container.
To Next Page
Loading...
Need help?
General
