Using the Operator Panel Menus and Keypad
346
• Dialing Type
Purpose:
To select the dialing type.
Values:
NOTE:
• The available values differ depending on your
Region
setting.
•Interval Timer
Purpose:
To specify the interval between transmission attempts within the range of 3 to 255 seconds. The
default is eight seconds.
• Number of Redial
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the
range of 0 to 9. If you enter 0, the printer will not redial. The default is 3.
• Redial Delay
Purpose:
To specify the interval between redial attempts within the range of 1 to 15 minutes. The default is one
minute.
• Junk Fax Filter
Purpose:
To reject faxes sent from unwanted numbers by accepting faxes only from the fax numbers registered
in the Address Book.
Values:
NOTE:
• Ensure to register the fax numbers you want to accept faxes from in the Address Book before using
Junk
Fax Filter
.
Tone*
Sets the dialing type to
Tone
.
DP (10PPS)
Sets the dialing type to Dial Pulse (10 pulse per second).
Off
* Does not reject faxes sent from unwanted numbers.
On
Rejects faxes sent from unwanted numbers.
To Next Page
Loading...
Need help?
General
