Using the Operator Panel Menus and Keypad
374
Enabling the Panel Lock
1
Press the System button.
2
Select Admin Menu, and then press the button.
3
Select Secure Settings, and then press the button.
4
Select Panel Lock, and then press the button.
5
Select Panel Lock Set, and then press the button.
6
Select Enable, and then press the button.
7
As necessary, select Change Password, and change the password using the numeric keypad.
Then, press the button.
NOTE:
• The factory-default panel password is 0000.
NOTE:
• Be sure to remember the password. The procedure described below allows you to reset the password.
However, for the DocuPrint M215 fw, the settings for the Address Book are cleared.
1
Turn off the printer. Then, while holding the
System
button, turn on the printer.
• If you change the password while
Panel Lock Set
is
Enable
, perform steps 1 to 2. Enter the current
password, and then press the button. Perform steps 3 to 4. Select
Change Password
, and then press
the button. Enter the new password, and then press the button. This will change the password.
To Next Page
Loading...
Need help?
General
