Fujitsu PRIMERGY RX1330 M5 User Manual

▶
If applicable, "Installing the front cover with lock" on page 61
.
7.5.7 Replacing the 4x 2.5-inch HDD backplane
(RX1330 M5S)
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less
The 4x 2.5-inch HDD backplane is available in a SAS/SATA or NVMe
variant depending on the configuration.
Preliminary steps
▶
"Locating the defective server" on page 43
.
▶
If applicable, "Removing the front cover with lock" on page 45.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
"Getting access to the component" on page 49.
▶
Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page 142.
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶
Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
139
.
Hard disk drive (HDD) / solid state disk (SSD)
154 Upgrade and Maintenance Manual RX1330 M5

Fujitsu PRIMERGY RX1330 M5 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX1330 M5
Category	Server
Language	English