FUTABA 7PX User Manual

Home screen
Menu screen
Menu-2
Menu-1
Linkage menu
Idle-up
72
Function
Idle-up
Idle-Up
This is a function select switch function. The idle up switch must be set (see page 69).
This function is used to improve engine starting performance by raising the idling speed
when starting the engine of a GP car (boat). It is also effective when you want to prevent the
braking when the power is turned off during running, due to the effect of your gear ratio
setting and choice of motor when operating an electronic car. However, considering safety,
and to prevent the motor from rotating instantly when the power is turned on, the MC-
950CR, MC851C, MC602C, MC402CR, and other Futaba electronic motor speed controller
(ESC) will not enter the operation mode if the neutral position is not con rmed. When us-
ing the MC950CR, MC851C, MC602C, MC402CR, or other Futaba ESC, con rm that the
ESC is in the neutral position and the set is in the operation mode before setting the idle up
function switch to ON.
Warning display
If the power switch is
turned on while the
Idle-up switch is on, an
audible alarm will be
heard. Immediately set
the Idle-up switch to
OF F.
Idle-up ON/OFF is indicated on
the home screen for a few sec-
onds.
It is displayed in the home
screen, when the Idle-up is ON.
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. Because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Operation
1M23N32602_7PX_E.indb 72 2017/08/02 14:17:21

FUTABA 7PX Specifications

General

Channels	7
Frequency	2.4GHz
Telemetry	Yes
Data Logging	Yes
Model Memory	40 models
Compatibility	T-FHSS, S-FHSS
System	T-FHSS
Display	4.3 inch color TFT LCD touch screen