FUTABA 7PX User Manual

Home screen
Menu screen
Menu-2
Menu-1
Linkage menu
Channel Limiter
Tap to turn on.
When the condition function is
turned on, the condition copy
display becomes active and the
condition is enabled.
76
Function
Condition
Two kinds of data can be set in one model for speci c functions only; for example, two
kinds of data such as steering D/R set to 90% at normal condition and steering D/R set to
80% at second condition. This second condition can be set for each model.
-The functions that can be set at each condition are displayed by condition number at the top
of the menu screen. Since the reverse function, end point and other model standard setup
menus are not displayed by conditioner number, the condition 1 and condition 2 settings are
common.
- To use the condition function, switch setting by the
"
Switch select
"
function (page 69) is
necessary.
- Switching from normal condition to second condition by switch set by switch select func-
tion is indicated by an audible alarm, and the condition number is displayed in the upper on
the screen.
-First, the initial settings of each condition 2 function are created.
-The data set at condition 2 is memorized until reset by data reset (page 175). The data
is memorized even if the condition function is turned off or setting of the switch by the
"
Switch select
"
function is changed.
Condition
1M23N32602_7PX_E.indb 76 2017/08/02 14:17:22

FUTABA 7PX Specifications

General

Channels	7
Frequency	2.4GHz
Telemetry	Yes
Data Logging	Yes
Model Memory	40 models
Compatibility	T-FHSS, S-FHSS
System	T-FHSS
Display	4.3 inch color TFT LCD touch screen