Figures
There are different type of figures included in this manual. Screens a nd
menus shown on the Information Display are one type of figure. These
figures are a direct "shot" of the Information Display of the machine
and have not been revised afterwards in order for the operator to
recognize current machine displays for the ongoing procedure. Some
figures illustrate handling or point out components of the machine.
To highlight certain items or illustrate movements arrows have been
included in t hese figures.
This "straight arrow" in figures points out details described in the
corresponding text. The arrow can also show a direction, i.e. if
somethingistobemovedinacertaindirection.
This "curved arrow" i n figures shows a direction of a rotation. This can
be the direction of s omething that is to be connected or opened/closed.
This "pressure arrow" appears in figures when something is to be
pressed in or pulled out. The point where the arrow points to is the
pressure/pulling point.
In addition, to highlight certain items, the details that the describing
text in the instructions aims at, are highlighted in gray in the
corresponding figure.
The buttons on the operator's panel light up in different situations to
guide the operator or to inform of current status. If the button is lit or
not is not normally illustrated in the handling instructions; the button
figures are the same for lit, flashing and not lit buttons. This is valid
for all instructions except for the alarm list (see "Alarm List" on page
13:9 in part 3) where the button figures also show status in order for
the operator to apprehend the instructions fully.
This is an example of a lit button.
This is an example of a flashing button.
A small reference number beside the figure has sometimes been added
to simplify manu
al production.
HCEN12239 Revision 12.2010
Program version 3.xx
AK 96
®
Operator's Manual - Before you get started
1:7
To Next Page
Loading...
Need help?
General
