Monitor setup
5-7
Changing the startup mode
1. Select Monitor Setup - Install/Service - Save Modes. Enter the password.
2. Select Startup Mode - 1, 2, 3, 4, 5, or 6.
Renaming a mode
1. Select Monitor Setup - Install/Service - Save Modes. Enter the password.
2. Select the mode, select Name and give a new name.
Loading modes
1. Select Monitor Setup - Install/Service - Save Modes. Enter the password.
2. Select Load Modes and one of the following:
• From Network: Loads all modes from network and saves them in monitor's
permanent memory.
• To Network: Copies all modes from monitor's permanent memory to network. This
selection is available only if saving modes to network is enabled in Central
To Next Page
Loading...
Need help?
General
