Safety
4-16 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
EMC (Electromagnetic Compatibility) (continued)
NOTE: Do not use devices which intentionally transmit RF Signals
(cellular phones, transceivers, or radio controlled products)
other than those supplied by GE (wireless microphone,
broadband over power lines, for example) in the vicinity of the
equipment as it may cause performance outside the published
specifications. Keep the power to these type devices turned off
when near this equipment.
The medical staff in charge of this equipment is required to
instruct technicians, patients, and other people who maybe
around this equipment to fully comply with the above
requirement.
EMC Performance
All types of electronic equipment may characteristically cause
electromagnetic interference with other equipment, either
transmitted through air or connecting cables. The term EMC
(Electromagnetic Compatibility) indicates the capability of
equipment to curb electromagnetic influence from other
equipment and at the same time not affect other equipment with
similar electromagnetic radiation from itself.
Proper installation following the service manual is required in
order to achieve the full EMC performance of the product.
The product must be installed as stipulated in 4.2, Notice upon
Installation of Product.
In case of issues related to EMC, please call your service
personnel.
The manufacturer is not responsible for any interference caused
by using other than recommended interconnect cables or by
unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the users’
authority to operate the equipment.
To Next Page
Loading...
Need help?
General
