GE LOGIQ V2 User Guide

Safety
4-20 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
Peripheral Update for EC countries
The following is intended to provide the users in EC countries
with updated information concerning the connection of the
LOGIQ V2/LOGIQ V1 to image recording and other devices or
communication networks.
Peripherals used in the patient environment
The LOGIQ V2/LOGIQ V1 has been verified for overall safety,
compatibility and compliance with the image recording devices
listed in Supplies/Accessories section.
The LOGIQ V2/LOGIQ V1 has also been verified for
compatibility, and compliance for connection to a local area
network (LAN) via the rear panel Ethernet connection, provided
the LAN components are IEC/EN 60950 compliant.
The LOGIQ V2/LOGIQ V1 has also been verified for
compatibility, and compliance for connection to a DVD-RW via
the system USB port, provided the DVD-RW is IEC/EN 60950
compliant.
A Wireless LAN option is available.
The LOGIQ V2/LOGIQ V1 may also be used safely while
connected to devices other than those recommended above if
the devices and their specifications, installation, and
interconnection with the system conform to the requirements of
IEC/EN 60601-1.
Accessory equipment connected to the analog and digital
interfaces must be certified according to the respective IEC
standards (i.e., IEC60950 for data processing equipment and
IEC60601-1 for medical equipment). Furthermore, all complete
configurations shall comply with the valid version of the system
standard IEC60601-1. Everyone who connects additional
equipment to the signal input part or signal output part of the
LOGIQ V2/LOGIQ V1 system configures a medical system, and
is therefore responsible to ensure that the system complies with
the requirement of the valid version of IEC60601-1. If in doubt,
consult the technical service department or your local GE
representative.

GE LOGIQ V2 Specifications

General

Brand	GE
Model	LOGIQ V2
Category	Medical Equipment
Language	English